Ariens 916302 amp 24 sno-thro, Руководство пользователя

Страница: 30 / 38

GB - 30
18. Connect pivot pin to speed selector arm.
See
Speed Selector Adjustment
on
page 23.
19. Install bottom cover.
20. Install wheels.
21. Return unit to upright position.
22. Install and connect batteries.
23. Adjust traction drive clutch. See
Traction
Drive Clutch Adjustment
on page 28.
SHORT TERM
Maintain battery charge.
IMPORTANT: Always keep battery charger
connected to batteries and a reliable power
source when Sno-Thro is not in use. Failure
to keep batteries fully charged will reduce
battery life and void battery warranty.
Run with attachment clutch engaged a few
minutes after each use to free unit of any
loose or melting snow.
Remove key from switch.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Follow all instructions under Short-Term
storage.
Clean unit thoroughly and lubricate (see
MAINTENANCE
on page 19).
Touch up all scratched painted surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
STORAGE
WARNING: AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Drive motor will not
run. 1. PTO switch in ON position
when key turned ON.
1. Turn PTO switch OFF before
turning key switch ON.
2. Traction or attachment
clutch levers engaged.
2. Release levers.
3. Discharged batteries. 3. Charge batteries (see
Charging
the Batteries
on page 16).
4. Disconnected batteries. 4. Connect both batteries to power
harness.
5. Faulty electrical system. 5. Contact your Ariens Dealer
6. Drive motor stops when
attachment lever is
engaged.
6. Charge batteries – Controller
senses low battery voltage
(see
Low Battery Voltage
on page 18).
Does not operate
in Forward /
Reverse. 1. Friction disc not adjusted
properly.
1. Repair or replace friction disc
(see Friction Disc Replacement
on page 29).
2. Traction belt not
functioning.
2. Repair or replace traction drive
belt
(see Traction Drive Belt
Replacement
on page 25).
3. Speed selector not
adjusted properly.
3. Adjust speed selector
(see
Speed Selector Adjustment
on
page 23).
4. Discharged batteries. 4. Charge batteries – Controller
senses low battery voltage
(see
Low Battery Voltage
on page 18).
Small rubber
beads collect in
frame. 1. Friction disc wear. 1. Normal friction disc wear. Chunks
or large pieces of rubber mean
friction disc should be checked
and replaced as necessary.