Ariens 916302 amp 24 sno-thro, Руководство пользователя

Страница: 15 / 38

GB - 15
Speed Selector
Position the Speed Selector in the
appropriate speed notch to control forward
and reverse travel.
IMPORTANT: DO NOT change motion from
forward to reverse with clutch engaged.
Forward speed can be changed without
declutching.
Snow Clean-Out Tool
Figure 11
To clear the discharge chute:
1. Move PTO and power switches to OFF
position. Remove key.
2. Wait 10 seconds and make sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool (1) from
the auger housing and use it to remove
the clog from the discharge chute.
4. Replace the snow clean-out tool on the
auger housing.
Remote Discharge Chute
Deflector Control
ALWAYS position discharge chute deflector
at a safe angle before engaging the auger.
Place deflector into position before operation.
DO NOT throw snow any higher than
necessary.
Place deflector remote in a forward notch to
throw snow lower. Place deflector remote in a
rearward notch to throw snow higher
Discharge Chute
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before engaging auger.
Discharge Chute Crank
IMPORTANT: If chute does not stay in set
position, adjust as directed in
SERVICE AND
ADJUSTMENTS
on page 21
,
or repair before
operation.
Rotate the chute with the discharge chute
crank handle.
IMPORTANT: DO NOT force frozen chute
controls. If frozen, take to warm place until
controls are free.
Axle Lock Pin
Figure 12
Use the axle lock pin to lock or unlock the
right or left wheel. Lock both wheels to
increase traction; unlock one wheel to allow
for easier turning of the unit.
NOTE: Unit will not drive with both wheels
unlocked.
WARNING: Hand contact with the
rotating impeller is the most common
cause of injury associated with snow
throwers. Never use your hand to
clean out the discharge chute.
OS2581
6 1 1 2
Forward
(6) Fastest
(1) Slowest
Reverse
(1) Slow
(2) Fast
Figure 11
OS2550
1. Snow Clean-Out Tool
1