ARI ARI-PACO 2G, Инструкции по эксплуатации и монтажу

Страница: 49 / 52

- Translated original instructions - 0040501006 2422 Page 2-49
Operating and installation instructions
Thrust actuator ARI-PREMIO
®
-Plus 2G
9.2 LED-encoding (from software version 2.1.7 and higher)
10.0 Dismantlement of thrust actuator
To dismantle the thrust actuator proceed as follows
:
- Loosen hexagon nut on the hood, carefully remove hood
- Disconnect all cables led into thrust actuator from outside and remove from thrust actuator.
- Place hood on carefully from above and fix in place with hexagon nut.
- Loosen grub screw inside torsion safety feature; screw coupling out of torsion safety feature.
- Loosen clamping bolts connecting the thrust actuator to the fitting.
- Remove thrust actuator from valve.
No initialization run Green Red
Blockage Green Red Orange
Y
in
control signal failure Green Red Yellow
ADV - outside the travel path Green Red Orange Yellow
Position kann nicht erreicht werden Green Red Orange Blue
Position can not be achieved Green Red Orange Yellow Blue
Motor error Green Red Blue
ATTENTION !
- The supply line for connecting up the thrust actuator must be in the dead state i.e.
disconnected while dismantlement work is being carried out. After being
disconnected, the mains power must be prevented from being switched back on
again accidentally.
- The system must be run down (depressurised state) as the valve cone is not held
without the thrust actuator and would thus be conducted by the system pressure.
- Valve plug approximately in mid lift position - on no account supported inside a seat!