V 11/17
55
however that the heat exchanger is not exposed to the danger of hail. If you want to attach the unit to
a wall, use brackets appropriately sized to support the weight of the unit. Condensation produced
due to the operation in heating can be piped to a drain using the appropriate predisposition.
Handling the unit
After unpacking make sure that the
content is intact and complete
The handling of the product must be
made by qualified and prepared
personnel, who are supplied with
suitable equipment made to support the
weight of the product.
The outdoor unit must always be kept
upright.
ù
Installation diagram and technicalspaces
The installation should be performed by qualified service personnel and experienced,
reliably and in compliance with this manual.
Contact your service centre prior to installation to prevent malfunction due to a
unprofessional installation.
In taking and moving the units it is necessary to be guided by qualified and experienced
people.
Make sure there is plenty space around the unit.
Collocation
Install junction and drain hose (only for models
with heat pump)
When the unit is in heating mode it produces
condensation, which flows from the outdoor unit.
In order not to disturb neighbors and to respect
the environment, install a fitting and a drain
hose that can steer the condensation water.
Install the discharge fitting and the rubber
gasket on the frame of the outdoor unit and
connect a drain hose as shown in figure.
Use bolts to secure the unit to the floor,
which must be a solid ground. When
installing the unit on the wall or on the
roof, make sure the support is firmly
secured so that it cannot move in the
event of severe vibration or high winds.
Warning: The installation must be
performed
in
compliance
with
NEC/CEC
rules
by
authorized
personnel only
.
•Do not install the outdoor unit in
cavities or air vents.
Содержание Ecolight 12000 UI
Страница 28: ...V 11 17 59 ...