Argo AEG ECO 100PIH, Руководство пользователя и инструкция по установке

Страница: 220 / 287

▲
▲
● When setting
T-ON,
T-OFF
o
r CLOCK, press "▲" or " " button to adjust time.
(Refer to CLOCK,
T-ON,
T-OFF buttons) When setting T-ON, T-OFF
o
r CLOCK
press "▲"
or
" " button t
o
adjust time. (Refer to CLOCK,T-ON, T-OFF buttons
)
4
Note:
● Press this button continuously more than 2s, the main unit will swing back and
forth from left to right, and then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immediately.
● Under swing left and right mode, when the status is switched from off to , if
press this button again 2s late
r
, status will switch to off status directly; if press
this button again within 2s, the change of swing status will also depend on the
circulation sequence stated above.
Introduction for buttons on remote controller
7
Press this button can select up & down swing angle. Fan blow angle can be selected
circularly as below:
● When selecting " ", air conditioner is blowing fan automatically. Horizontal
louver will automatically swing up & down at maximum angle.
● When selecting "
、 、 、 、
", air conditioner is blowing fan at fixed
position. Horizontal louver will stop at the fixed position.
● When selecting "
、 、
", air c
o
nditioner is blowing fan at fixed angle.
Horizontal louver will send air at the fixed angle.
● Hold " " button above 2s to set your required swing angle. When reaching your
required angle, release the button.
Note:
● "
、 、
" may not be available. When air conditioner receives this signal, the
air conditioner will blow fan automatically.
● Press this button continuously more than 2s, the main unit will swing back and
forth from up to down, and then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immediately.
● Under swing up and down mode, when the status is switched from off to , if
press this button again 2s late
r
, status will switch to off status directly; if press
no display
(horizontal louvers stops
at current position)
button
this button again within 2s, the change of swing status will also depend on the
circulation sequence stated above.
6
Press this button can select left & right swing angle. Fan blow angle can be selected
circularly as below:
button
no display
(st
o
ps at current position
)