7-8
MD2014
9. Place the axle housing into position on the
swing arm; then install and tighten four cap
screws to specifications.
10. Install the brake caliper on the axle housing with
the two cap screws. Tighten securely.
KM229
11. Install the wheels and tighten the cap screws to
specifications; then remove the ATV from the
support stand.
Wheels and Tires
TIRE SIZE
The ATV is equipped with low-pressure tubeless
tires of the size and type listed (see Section 1). Do
not under any circumstances substitute tires of a dif-
ferent type or size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.21
kg-cm
2
(3.0 psi).
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
2. Remove the four cap screws securing each
wheel; then remove the wheels.
NOTE: Keep left-side and right-side wheels sepa-
rated for installing them on their proper sides.
! WARNING
After removing and installing of components that
are brake-related, ALWAYS check and adjust brakes
as necessary before operating the ATV.
! WARNING
Use only Arctic Cat approved tires when replacing
tires. Failure to do so could result in unstable ATV
operation.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning could
cause poor handling qualities of the ATV and could
cause excessive drive train damage not covered by
warranty.
! WARNING
Always maintain proper tire inflation pressure.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
