Arctic Cat HDX, Руководство оператора

Страница: 49 / 66

47
9. Start the vehicle with the dead bat-
tery and allow it to run for several
minutes before disconnecting the
jumper cables.
10. Remove the jumper cables in oppo-
site order of hook-up (4, 3, 2, 1). Be
careful not to short cables against
bare metal.

NOTE: Have the battery and elec-
trical system checked prior to oper-
ating the vehicle again.
Spark Plug(s)
This vehicle comes equipped with a speci-
fied spark plug. See the specifications
chart for the correct spark plug. A light
brown insulator indicates that the plug is
correct. A white or dark insulator indicates
that the engine may need to be serviced.
Consult an authorized Arctic Cat dealer if
the plug insulator is not a light brown
color. To help prevent cold weather foul-
ing, make sure to thoroughly warm up the
engine before operating.
To maintain a hot, strong spark, keep the
plug free of carbon.
ATV-0051
Before removing the spark plug, be sure
to clean the area around the spark plug. If
you do not, dirt could enter engine when
removing or installing the spark plug.
Adjust the gap (see specifications chart)
for proper ignition. Use a feeler gauge to
check the gap.
ATV-0052
A new spark plug should be tightened 1/2
turn once the washer contacts the cylinder
head. A used spark plug should be tight-
ened 1/8 - 1/4 turn once the washer contacts
the cylinder head.
Air Inlet Pre-Filter
(HDX)
This vehicle is equipped with a foam pre-
filter to filter dirt from the inlet air prior
to reaching the main air filter.

NOTE: To access the pre-filter,
remove the seat and backrest; then
remove the seat base.
1. Gently squeeze the pre-filter cover
and lift it up to expose the pre-filter.
HDX237A
2. Loosen the clamp securing the pre-
filter.
HDX235