96
B. On the 400 FIS/ACT, place the
filter in the air filter housing
making sure it is properly in
position and seated and secure
with the clamp; then install the
cover and secure with the
retaining clips.
C. On the 400 TBX/500/650/650
V-Twin, place the storage com-
partment into position; then
secure with the fasteners.
10. Install the seat making sure it is
properly secured.
AIR FILTER HOUSING
DRAIN TUBE
Periodically (weekly) check the drain
tube for gasoline or oil accumulation.
If noticed, remove the drain tube cap
from beneath the front housing, drain
the gasoline or oil into a suitable con-
tainer, and install and secure the tube
cap.
Inspect the “duck bill” drain beneath
the main housing for debris and for
proper sealing.
733-715B
ATV-0087
KX045A
DRAINING V-BELT
COVER (Automatic
Transmission)
NOTE: If the ATV has been
driven through water, the V-belt
cover must be drained of any
water.
On the 400/500/650 to drain the belt
cover, use the following procedure.
AF922A
1. Place the ATV on a level surface.
2. Remove the drain bolt from the
cover and allow the water to drain
out.
3. Shift the range lever to the neutral
position; then start the engine.
4. Increase and decrease engine RPM
several times to “blow out” any
water; then stop the engine.
250/300
400 FIS/ACT
! CAUTION
The drain on the right side of the
housing is on the “clean air”side of
the air filter. Any leak in this drain
will allow unfiltered air to enter the
engine. Severe engine damage
could occur.
400 TBX/500/650/650 V-Twin
400/500/650