86
7. Start the engine (while the ATV is
outside on level ground) and allow
it to idle for a few minutes.
8. Turn the engine off and wait
approximately one minute.
Recheck the oil level.
9. Inspect the area around the drain
plug and oil filter for leaks.
Front Differential And
Rear Drive Gear
Lubricant
(Inspecting/Changing)
Inspect and change the gear lubricant
in each according to the Maintenance
Schedule. When changing the lubri-
cant, use approved SAE 80W-90 hyp-
oid oil and use the following
procedure.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
0736-568
3. Drain the oil into a drain pan by
removing in turn the drain plug
from each.
ATV0082A
ATV-1096
737-651A
4. After all the oil has been drained,
install the drain plugs and tighten
securely.
5. Pour recommended oil into each
filler hole.
6. Install the filler plugs.
ATV-0077
! CAUTION
Inspect the oil for any signs of metal
filings or water. If found, take the
ATV to an authorized Arctic Cat ATV
dealer for servicing.
Rear Drive
400 ACT
400 ACT