64
6.
Clock/Hour Meter Display But-
ton
— Press the display button to
switch to either the clock or hour
meter and in conjunction with the
Odometer/Trip Meter Display But-
ton (1), the speedometer km/h and
mph displays.
NOTE: The clock icon indicates a
12-hour mode; the hour meter icon
indicates total time the ATV is
used.
A. Press and hold the display but-
ton until the minute display
blinks; then adjust the minute
display by pressing the button.
Press the Odometer/Trip Meter
Display Button (1) to set min-
ute display.
NOTE: If the display button is
pressed in and held, the minute
display will advance continuously.
B. After the minute display is set,
the hour display will blink.
Press the Clock/Hour Meter
Display Button (6) to set hour
display.
7.
Speedometer
— Shows approxi-
mate ATV speed in km/h and mph.
NOTE: To display km/h or mph,
press Display Button (1) to odome-
ter; then press and hold Display
Button (1) while pressing Clock/
Hour Meter Display Button (6) for
two seconds. Speedometer will
display between km/h and mph.
8.
Clock/Hour Meter
— Clock indi-
cates 12-hour mode; the hour
meter indicates total time the ATV
is used.
9.
4WD Indicator
— Displays 4WD
when the front drive selector
switch is moved to the 4WD posi-
tion. Display will go off when
2WD is selected.
10.
Odometer/Trip Meters (A & B)
— Odometer registers the total dis-
tance the ATV has traveled. Trip
meters can register two different
types of distances (for instance, A
could register trip distance and B
could register distance between
stops). Trip meters can be reset.
11.
Gear Position Indicator
— Dis-
plays which position the shift lever
is in: R (reverse gear) and the
Reverse Indicator (2) will illumi-
nate, N (neutral) and the Neutral
Indicator (3) will illuminate, and
on the automatic transmission
model H (high gear), and L (low
gear).
12.
Fuel Level Indicator
— Shows
amount of gasoline in the gas tank.
Speedometer/Indicator
Lights (650 V-Twin)
NOTE: The indicator lights will
illuminate for approximately one
second when the ignition switch is
rotated to the ON position.
1.
Set/Reset Button
— Used (in con-
junction with the Time Set button)
to advance the hour and minute
display for setting the clock and to
reset the trip meter display to zero.
2.
Belt Check Indicator
— The Belt
light will flash at 0.35-second
intervals when excessive belt wear
or belt damage is detected. Also,
light will illuminate every 100
hours of operation to indicate ser-
vice requirements.