Arctic Cat 2014 Prowler HDX, Руководство по обслуживанию

Страница: 97 / 192

94
CD470
CD471
26. Loosen the four adjuster screw jam nuts; then loosen
the four adjuster screws on the rocker arms in the
valve cover.
CC005D
27. Apply a thin coat of Three Bond Sealant to the mat-
ing surfaces of the cylinder head and valve cover.
CC275D
28. Place the valve cover into position.

NOTE: At this point, the rocker arms and adjuster
screws must not have pressure on them.
29. Install the four top side cap screws with rubber wash-
ers; then install the remaining cap screws. Tighten
only until snug.
CC003D
30. In a crisscross pattern starting from the center and
working outward, tighten the cap screws (from step
29) to 8.5 ft-lb.
31. Adjust valve/tappet clearance (see Periodic Mainte-
nance).
32. Place the two tappet covers into position making sure
the proper cap screws are with the proper cover.
Tighten to 8.5 ft lb.
CC001D
33. If removed, install the spark plug. Tighten securely.
Left-Side Components

NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.

AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.