Arctic Cat 2014 Prowler HDX, Руководство по обслуживанию

Страница: 14 / 192

11
HDX042A
6. Start the engine (while the vehicle is outside on level
ground) and allow it to idle for a few minutes.
7. Turn the engine off and wait approximately one minute;
then unscrew the oil level stick and wipe it with a clean
cloth.
8. Install the oil level stick and thread into the engine case.
9. Remove the oil level stick; the oil level must be within
the operating range but not exceeding the upper mark.
GZ461A
10. Inspect the area around the drain plug and oil filter for
leaks.
Front Differential - Rear
Drive Lubricant
To check lubricant, use the following procedure.
1. Remove the level plug (B); the lubricant should be
level with the bottom threads.
HDX221A
2. If low, remove the fill plug (A) and add the appropriate
lubricant until it appears at the bottom of the level plug
threads.
To change the lubricant, use the following procedure.
1. Place the vehicle on level ground.
2. Remove each fill plug.
3. Drain the lubricant into a drain pan by removing in turn
the drain plug from each.
HDX255
HDX220A
4. After all the lubricant has been drained, install the drain
plugs and tighten to 45 in.-lb.
5. Pour the appropriate amount of recommended lubricant
into the fill hole.
6. Install the fill plug and tighten to 16 ft-lb.
CAUTION
Any oil used in place of the recommended oil could
cause serious engine damage. Do not use oils which
contain graphite or molybdenum additives. These oils
can adversely affect clutch operation. Also, not recom-
mended are racing, vegetable, non-detergent, and cas-
tor-based oils.
CAUTION
Do not over-fill the engine with oil. Always make sure
that the oil level is not above the upper mark.
700