Arctic Cat 2014 Prowler HDX, Руководство по обслуживанию

Страница: 173 / 192

170
3. Using a socket and ratchet handle, tighten the nut
until the stud is fully drawn into the hub.
PR252A
INSTALLING
1. Secure the brake disc (if applicable) to the hub with
the four cap screws coated with red Loctite #271.
Tighten to 15 ft-lb.
2. Apply grease to the splines in the hub.
PR254B
3. Install the hub assembly onto the axle; then place the
transmission in park.
PR221
4. Secure the hub assembly with the nut. Tighten to 200
ft-lb; then secure with a new cotter pin.

NOTE: If the cotter pin cannot be inserted due to
misalignment of the hole in the axle and the slots in
the nut, tighten the nut until properly aligned.
PR258
5. Secure the brake calipers to the knuckle with two
new “patch-lock” cap screws tightened to 20 ft-lb.
PR377B
6. Install the wheel and tighten in 20 ft-lb increments to
40 ft-lb (steel wheel) or 80 ft-lb (aluminum wheel).
7. Remove the vehicle from the support stand.
Hydraulic Brake Caliper
REMOVING/DISASSEMBLING
1. Secure the vehicle on a support stand to elevate the
wheel; then remove the wheel.
2. Drain the brake fluid from the caliper, hose, and
master cylinder through the bleed screw by pumping
the brake pedal.
! WARNING
Arctic Cat recommends only authorized Arctic Cat ROV
dealers perform hydraulic brake service. Failure to
properly repair brake systems can result in loss of con-
trol causing severe injury or death.
! WARNING
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
! WARNING
Never let brake fluid contact the eyes. Damage to the
eyes will occur. Always wear appropriate protective
safety goggles and latex gloves when handling brake
fluid.