76
7. Attach one clamp of the negative
(black) jumper cable to the negative
(-) terminal (3) of the good battery
(B); then attach the other clamp of
the negative (black) jumper cable (4)
to an unpainted metal surface (A) on
the engine or frame well away from
the dead battery and fuel system
components.
8. Stand well away from the dead bat-
tery and start the vehicle with the
good battery. Allow the vehicle to
run for several minutes applying
some charge to the dead battery.
9. Start the vehicle with the dead bat-
tery and allow it to run for several
minutes before disconnecting the
jumper cables.
10. Remove the jumper cables in oppo-
site order of hook-up (4, 3, 2, 1). Be
careful not to short cables against
bare metal.
NOTE: Have the battery and elec-
trical system checked prior to
operating the vehicle again.
Spark Plug(s)
This ATV comes equipped with a speci-
fied spark plug. See the appropriate speci-
fications chart for the correct spark plug.
A light brown insulator indicates that the
plug is correct. A white or dark insulator
indicates that the engine may need to be
serviced. Consult an authorized Arctic
Cat ATV dealer if the plug insulator is not
a light brown color. To help prevent cold
weather fouling, make sure to thoroughly
warm up the engine before operating.
To maintain a hot, strong spark, keep the
plug free of carbon.
Before removing the spark plug, be sure
to clean the area around the spark plug. If
you do not, dirt could enter engine when
removing or installing the spark plug.
ATV-0051
Adjust the gap to specification for proper
ignition (see appropriate specification
chart). Use a feeler gauge to check the gap.
ATV-0052
When installing the spark plug, be sure to
tighten it securely. A new spark plug should
be tightened 1/2 turn once the washer con-
tacts the cylinder head. A used spark plug
should be tightened 1/8 - 1/4 turn once the
washer contacts the cylinder head.
Throttle Cable
Adjustment
To adjust the throttle cable free-play:
1. Loosen the jam nut from the throttle
cable adjuster.
2. Slide the rubber boot away and turn
the adjuster until the throttle lever
has proper free-play of 3-6 mm (1/8-
1/4 in.).
ATV-0047
! WARNING
Never make the final connection to a
battery as a spark could ignite hydro-
gen gases causing an explosion of
the battery resulting in acid burns or
blindness.
2011 TRV
2012 TRV
Содержание 2012 700 i Cruiser
