34
Main Table of Contents
3. While holding the brake lever lock down, release the brake lever.
NOTE: The brake lever will not return to its released posi-
tion.
4. Release the brake lever lock by compressing the brake lever. It
will return to its released position.
Check to make sure the brake lever lock engages properly and that
the brake (when engaged) locks the rear wheels.
1. Engage the brake lever lock.
2. Attempt to push the ATV.
NOTE: The brake must lock the wheels. If it doesn’t, the
hydraulic brake system must be serviced.
Headlight Switch
Use the headlight switch to select
the high or low headlight beam or
parking lights when the ignition
switch is in the LIGHTS position.
When the switch is in the High
Beam position, the high beam
will illuminate. When the switch
is in the Low Beam position, the
low beam will illuminate. When
the switch is in the Running
Lights position, the running lights will illuminate.
Engine Stop Switch
This switch will stop the engine.
The engine can be started again
by pressing the yellow starter
button.
STOP position
— The ignition
circuit is off. The engine cannot
be started or will not run. If the
engine stop switch is used to stop
engine without turning off ignition switch, the battery may discharge.
RUN position
— The ignition circuit is on. The engine can start and
run.
Electric Starter Button
Pushing in on this button activates the starter motor. Before starting
the engine, make sure the ignition switch is in the ON position and
the brake lever lock is engaged.
Throttle Lever
Control engine RPM with the
position of the throttle lever. Oper-
ate this lever with the thumb.
Pushing it forward increases
engine RPM and allowing it to
retract decreases engine RPM.
Throttle Limiter
Screw
Throttle lever travel may be limited by adjusting the throttle limiter
screw. The throttle limiter should be adjusted according to the opera-
tor’s skill and experience. To adjust the throttle limiter, use the fol-
lowing procedure.
1. Loosen the jam nut.
! WARNING
Always check to be sure that the brake lever lock has been
disengaged before operating the ATV. An accident could
result if a brake is left engaged while the ATV is operated.
Always block the downhill side of the wheels if leaving the
ATV on a hill or park the ATV in a sidehill position.
KM850A
KM850B
KM859
2012 T-14
Содержание 2012 700 i Cruiser
