43
Divis
ion
II
- Opera
tion
/
Ma
inte
nance
Use the headlight HI/LO switch to select
the high or low headlight beam when the
ignition switch is in the LIGHTS posi-
tion. When the switch is in the HI posi-
tion, the high beam will illuminate. When
the switch is in the LO position, the low
beam will illuminate. When the switch is
in the Running Light position, the tail-
lights and running lights will illuminate.
Engine Stop Switch
OFF position — The ignition circuit is
off. The engine cannot be started or will
not run. If the engine stop switch is used
to stop engine without turning off igni-
tion switch, the battery may discharge.
RUN position — The ignition circuit is
on. The engine can start and run.
Starter Button
Pushing in on this button activates the
starter motor. Before starting the engine,
make sure the ignition switch is in the
ON position, the transmission is in neu-
tral, and the brake lever lock is engaged.
NOTE: This ATV has safety inter-
lock switches which prevent the
starter motor from activating when
the transmission is not in neutral.
Reverse Override Switch
This ATV is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch
NOTE: On the 425, the reverse
override switch is active in 4WD
only.
Throttle Lever
KC342A
Control engine RPM with the position of
the throttle lever. Operate this lever with
the thumb. Pushing it forward increases
engine RPM and allowing it to retract
decreases engine RPM.
Throttle Limiter Screw
ATV-0053
Throttle lever travel may be limited by
adjusting the throttle limiter screw. The
throttle limiter should be adjusted
according to the operator’s skill and
experience. To adjust the throttle limiter,
use the following procedure.
1. Loosen the jam nut.
2. Turn the throttle limiter screw clock-
wise to decrease engine RPM maxi-
mum or counterclockwise to
increase engine RPM maximum.
3. Tighten the jam nut securely.
NOTE: The ATV is equipped with
an RPM limiter that retards ignition
timing when maximum RPM is
approached. When the RPM limiter
is activated, it could be misinter-
preted as a high-speed misfire.
! WARNING
Never activate the override switch
while the throttle is open as a loss of
control may result.
2012 350-425
Содержание 2012 700 i Cruiser
