50
Hand Brake Lever/Brake
Lever Lock
738-420B
The hand brake is considered to be the
normal operating (main) brake. It should
be applied whenever a braking situation
is needed.
Apply the brake by compressing the
brake lever toward the handlebar.
To engage and release the brake lever
lock, use the following procedure.
1. Squeeze the hand brake two or three
times and release it.
2. Depress and hold the brake lever
lock.
3. While holding in on the brake lever
lock, squeeze the brake lever.
NOTE: It will click as it engages
and the brake lever will not return to
its released position.
4. Release the brake lever lock by
squeezing the brake lever. It will
return to its released position.
Check to make sure the brake lever lock
engages properly and that the brake
(when engaged) locks the wheels.
1. Pump the brake lever 2 or 3 times.
2. Engage the brake lever lock.
3. Attempt to push the ATV.
NOTE: The brake lever lock must
lock the wheels. If it doesn’t, take the
ATV to an authorized Arctic Cat ATV
dealer for service.
Headlight HI/LO Switch
CF245A
Use the headlight HI/LO switch to select
the high or low headlight beam when the
ignition switch is in the LIGHTS position.
When the switch is in the HI position, the
high beam will illuminate. When the
switch is in the LO position, the low beam
will illuminate.
Engine Stop Switch
OFF position — The ignition circuit is off.
The engine cannot be started or will not
run. If the engine stop switch is used to
stop engine without turning off ignition
switch, the battery may discharge.
RUN position — The ignition circuit is
on. The engine can start and run.
Starter Button
Pushing in on this button activates the
starter motor. Before starting the engine,
make sure the ignition switch is in the
ON position, the transmission is in neu-
tral, and the brake lever lock is engaged.
! WARNING
Always check to be sure that the brake
lever lock has been disengaged before
operating the ATV. An accident could
result if the brake lever lock is left
engaged while the ATV is operated.
The brake may relax if left engaged for
a long period of time. This could
cause an accident; therefore, do not
leave the ATV on a hill depending on
the brake lever lock. Always block the
downhill side of the wheels if leaving
the ATV on a hill or park the ATV in a
sidehill position.
2012 Generic ATV
Содержание 2012 700 i Cruiser
