48
Main Table of Contents
General Lubrication
Cables
None of the cables require lubrication; however, it is advisable to lubri-
cate the ends of the cables periodically with a good cable lubricant.
Engine/Transmission Oil and Filter
NOTE: Refer to the recommended oil viscosity chart (on
page 44) in this manual for the proper engine oil.
Change the engine oil and oil filter at
the scheduled intervals. The engine
should always be warm when the oil
is changed so the oil will drain easily
and completely.
1. Park the ATV on level ground.
2. Remove the oil level stick. Be
careful not to allow contami-
nates to enter the opening.
3. Remove the drain plug from
the bottom of the engine and
drain the oil into a drain pan.
4. Remove the oil filter plug from
the filter mounting boss (located
on the front-right side of the
transmission case) and allow the
filter to drain completely.
5. Using the oil filter wrench and a ratchet handle (or a socket or
box-end wrench), remove the old oil filter and dispose of prop-
erly. Do not re-use oil filter.
NOTE: Clean up any excess oil after removing the filter.
6. Apply oil to the new filter O-ring and check to make sure it is posi-
tioned correctly; then install the new oil filter. Tighten securely.
7. Install the oil filter drain plug and tighten securely.
8. Install the engine drain plug and tighten it securely. Pour the rec-
ommended oil in the filler hole. Install filler plug.
9. Start the engine (while the ATV is outside on level ground) and
allow it to idle for a few minutes.
10. Turn the engine off and wait approximately one minute. Recheck
the oil level.
11. Inspect the area around the drain plug and oil filter for leaks.
Front Differential and
Rear Drive Gear
Lubricant (Inspecting/
Changing)
Inspect and change the gear lubri-
cant in each according to the Main-
tenance Schedule. When changing
the lubricant, use approved SAE
80W-90 hypoid oil and use the fol-
lowing procedure.
1. With the ATV on level ground,
remove each oil filler plug.
2. Drain the oil into a drain pan by
removing in turn the drain plug
from each.
3. After all the oil has been
drained, install the drain plugs
and tighten securely.
KC0051A
733-441A
CAUTION
Inspect the oil for any signs of
metal filings or water. If found,
take the ATV to an authorized Arc-
tic Cat ATV dealer for servicing.
CF107B
CF106C
CF113A
2012 XC 450 i
Содержание 2012 700 i Cruiser
