Arctic Cat 2006 DVX 400, Руководство оператора

Страница: 9 / 32

Page 17
CONTROL LOCATIONS AND FUNCTIONS
Ignition switch
The ignition switch has three positions:
OFF-Position: All electrical circuits except the accessory
plug are off. The engine will not start. The key can be
removed in this position.
ON-Position: The ignition circuit is complete and the engine can run. The key cannot be
removed in this position. The lights are off.
!! CAUTION !!
Leaving the ignition switch in the LIGHTS position for a long period of time when the engine is
not running may cause the battery to discharge. Always leave the ignition switch in the OFF
position when engine is not running.
LIGHTS POSITION: The ignition circuit is complete and the headlights and taillight are on. The
key cannot be removed in this position.
Speedometer/Indicator Lights
1. Speedometer:
The speedometer shows approximate speed.
2. Odometer: The odometer shows the total distance traveled.
3. Trip Meter: The trip meter is an odometer which can be reset. It can be used to show
the distance traveled on short trips or between gas stops.
4. High Beam Indicator: A blue light will illuminate when the lights are on high beam.
The light will not be illuminated when the lights are switched to low beam.
5. Temperature Indicator: A red light will illuminate if the engine overheats
300
Page 18
NOTE: High engine RPM, low vehicle speed or heavy load can raise engine
temperature. Decreasing engine RPM, reducing load and selecting an appropriate
transmission gear can lower the temperature.
NOTE: Debris in front of the engine or packed between the oil cooler/radiator cooling
fins can reduce cooling capability. Clean the engine and oil cooler/radiator to remove any
debris preventing air flow.
6. Neutral Indicator: A green light will illuminate when the transmission is in neutral and
the ignition switch is on. The light will go out when shifted into any gear other than
neutral.
7. Reverse Indicator: An orange light will illuminate when the transmission is shifted
into reverse gear.
!! CAUTION !!
A continuous use of the ATV with low oil pressure can cause engine damage or a
premature wear of the engine.
!! ATTENTION !!
A continuous use of the ATV with low oil pressure can cause engine damage or a premature
wear of the engine.
Gearshift Pedal
Your QUAD disposes of a 5-gear transmission.
The gearshift pedal is attached to a ratchet
mechanism in the transmission. Each time a gear
is selected, the gearshift pedal will return to its
normal position ready to select the next gear. To
return to the idling position, pull the clutch lever
and activate the gearshift pedal until you have
reached the idling position. Shift into first gear by
pressing down on the front of the pedal. The
other gears are reached by pulling up the pedal
on the front side.