Arctic Cat 2006 DVX 400, Руководство оператора

Страница: 14 / 32

Page 27
GENERAL MAINTENANCE
NOTE: Proper maintenance of the ATV is important for optimum performance. Follow all
given instructions.
If, at any time, abnormal noises, vibrations, or improper functioning of any component of this
ATV is detected, DO NOT OPERATE THE ATV. Take the ATV to an authorized ACE ATV dealer
for inspection and adjustment or repair.
NOTE: The following instructions and information refer to specific items in the
maintenance and care of the ATV.
GENERAL LUBRICATION
Cables
None of the cables require lubrication; however it is advisable to lubricate the ends of the
cables periodically with a good cable lubricant.
Engine/Transmission Oil and Filter
Change the engine oil and oil filter at the scheduled intervals. The engine should always be
warm when the oil is changed so the oil will drain easily and completely.
1. Park the ATV on level ground.
2. Remove the oil filler plug. Be careful not to allow contaminates to enter the opening.
3. Remove the drain plugs from the bottom of the engine and drain the oil into a drain pan.
4. Remove the oil filter plug from the filter mounting boss (located on the front-right side of
the transmission case) and allow the filter to drain completely.
5. Remove the old oil filter and dispose of properly. Do not re-use oil filter.
6. Apply oil to the new filter O-ring and check to make sure it is positioned correctly.; then
install the new oil filter.
7. Install the oil filter drain plug and tighten securely
8. Install the engine drain plug and tighten it securely. Pour the recommended oil into the
filter hole. Install filter plug.
9. Start the engine and allow it to idle for a few minutes.
10. Turn the engine off and wait approximately one minute. Recheck the oil level in the
engine oil inspection window.
11. Inspect the area around the drain plug and oil filter for leaks.
Page 28
Brake pads
The clearance between the brake pads and brake discs is adjusted automatically as the
brake pads wear. Check the thickness of each of the brake pads as follows:
1. Remove a front wheel.
2. Measure the thickness of each brake pad.
3. If thickness of either brake pad is less than
2,0 mm (0.078 in.), have brake pads
replaced. Install the wheel and tighten to
80-95 Nm.
Hydraulic Brake
The hydraulic brake must be properly maintained to be fully functional.
1.
Press the foot brake pedal or the hand brake
at the handlebars respectively.
2. With the engine off, transmission in neutral
and the reverse lever in the forward position,
attempt to move the ATV.
3. If the front and the rear wheels are locked, it
is adjusted properly.
4. If the wheels are not locked, it must be adjusted (set up).
!! ATTENTION !!
Be sure to inspect the hydraulic brake system before each use. Always maintain brakes
according to the maintenance schedule.
Foot Brake Pedal Foot Brake Pedal Foot Brake Pedal Foot Brake Pedal