Arctic Cat 2006 DVX 400, Руководство оператора

Страница: 12 / 32

Page 23
!! CAUTION !!
You should change the engine and transmission oil of your ATV every 2000km. Please
respect in this regard the maintenance schedule in your service booklet.
Filling Gas Tank
!! ATTENTION !!
Always fill the gas tank in a well-ventilated area. Never add gasoline to the ATV gas tank
near any open flames or with the engine running or hot. DO NOT SMOKE while filling the gas
tank.
Since gasoline expands as its temperature increases,
the gas tank must be filled to its rated capacity only.
Allow the engine to cool before filling the gas tank.
Care must be taken not to overfill the tank. If
overfilled, gas may leak onto the engine creating a fire
hazard.
Tighten the gas tank cap securely after filing the tank.
!! ATTENTION !!
Do not overfill the gas tank.
Page 24
BREAK-IN PROCEDURE
New ATV’s and renewed ATV engines require a „break-in“ period. The first month is most
critical to the life of this ATV. Proper operation during this break-in period will help assure
maximum life and performance from the ATV.
During the first 10 hours of operation, always use less than ½ throttle. Varying the engine
RPM during the break-in period aids the engine/transmission component mating
process. Although it is essential to place some stress on the engine components during
break-in, care should be taken not to overload the engine too often. Do not pull a trailer
during the break-in period.
When the engine starts, allow it to warm up properly. Idle the engine several minutes
until the engine has reached normal operating temperature. Do not idle the engine for
excessively long periods of time.
During the break-in period, you should not use more than ½ throttle. Short acceleration
maneuvers and riding at different velocities provide an optimum break-in of the engine.
During the break-in period you must also burnish brake pads (hydraulic brake) to achieve
full braking effectiveness. To properly burnish the brakes, use the following procedure:
1.
Choose an area sufficiently large to safely accelerate ATV to 30 km/h.
2. Accelerate to 30 km/h. then compress foot brake to decelerate to 0-5 km/h.
3. Repeat procedure 20 times until brakes are burnished.
After having finished this procedure, follow the same steps to burnish the hand brake.
Doing so, stabilizes the material and prolongs life of brake pads.
!! ATTENTION !!
Don’t make sudden braking maneuvers, unless brake pads aren’t burnished.
After the completion of the break-in period, the engine oil and oil filter should be
changed. Other maintenance after break-in should include checking of all prescribed
adjustments and tightening of all fasteners. Your ACE ATV dealer will be pleased to do
this initial service.