Arctic Cat 2006 DVX 400, Руководство оператора

Страница: 19 / 32

Page 37
Fuses
The fuses are located in front of the horn and the blinker-relay.
NOTE: To remove the fuse, compress the locking tabs on either side of the fuse case.
If there is any type of electrical system failure, always
check the fuses first.
!! CAUTION !!
Always replace a blown fuse with a fuse of the same type and rating. If the new fuse blows
after a short period of use, consult an authorized ACE ATV dealer immediately.
Tools
Under the seat of your ATV you’ll find a basic tool kit.
Maintain the tool kit with the ATV at all times.
20A
Page 38
PREPARATION FOR STORAGE
!! CAUTION !!
Prior to storing the ATV, it must be properly serviced to prevent rusting and component
deterioration.
ACE recommends the following procedure to prepare the ATV for storage. An authorized
Arctic Cat ATV dealer should perform this service; however the owner/operator may perform
this service if desired:
1. Clean the seat cushion with a damp cloth.
2. Clean the ATV thoroughly by washing dirt, oil, grass and other foreign matter from the
entire ATV. DO NOT get water into any part of the engine or air intake. Allow the ATV to
dry thoroughly.
3. Either drain the gas tank or add a fuel stabilizer to the gas in the gas tank. Remove the
air filter. Start the engine and allow it to idle. Then using Arctic Cat Engine Preserver,
rapidly inject the preserver into the air filter opening for a period of 10 to 20 seconds.
Install the air filter.
!! CAUTION !!
If the interior of the air filter housing is dirty, clean the area before starting the engine.
4. Drain the carburetor float bowl.
5. Plug the hole in the exhaust system with a clean cloth.
6. Apply light oil to the upper steering post bushing and plungers of the shock absorbers.
7. Take care that all screws, nuts and holding components are tightened properly.
8. Clean the ATV thoroughly.
9. Disconnect the battery cables (negative cable first); then remove the battery, clean the
battery posts and cables and store in a clean, dry area.
10. If possible, store the ATV indoors.
!! CAUTION !!
Avoid storing outside in direct sunlight and avoid using a plastic cover as moisture will collect
on the ATV causing rusting.