ZyWAN User Manual
Getting started with your ZyWAN
© 2008 Arcom Issue D
24
Initial configuration with a single PC
The ZyWAN typically comes factory loaded with default settings, which needs to be
configured for the network on which it will ultimately be used. The instructions in the
following two sections describe how to set up the hardware and software necessary to
perform this initial configuration.
Ethernet port ‘0’ is used in this section, which typically comes with standard
settings of address 192.168.1.1, subnet mask 255.255.255.0, and operating as
a DHCP server. In some cases, the ZyWAN may come factory loaded with
different settings. The instructions given here may or may not apply, depending
on the customer configuration.
The simplest way to start the ZyWAN and perform an initial configuration is to use a
direct connection to another computer (PC). To do this, you should carry out the
following:
•
Connect the configuration PC using a crossover Ethernet cable.
•
Apply power to the ZyWAN.
•
Set up the PC’s network settings.
•
Configure the ZyWAN via its Web page.
These actions are explained below.
Connect the configuration PC
Connect a crossover Ethernet cable from the network port labeled ‘0’ on the ZyWAN to
an Ethernet port on the PC as shown below:
Configuration PC
Crossover Ethernet Cable
ZyWAN
The crossover Ethernet cable may be purchased from Arcom Control Systems, or it
may be obtained from a network equipment supplier.
Apply power
Connect the power supply to a wall outlet and to the 4-position power connector on the
ZyWAN. See
Power connection
on page
18
for the power input socket pin configuration
details.