8 /35 EN
Refrigerator / User Manual
3
Installation
3.1 Appropriate installation location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and ensure
that electrical installation and water
installation are appropriate. If not, call a
qualified electrician and technician to have
any necessary arrangements carried out.
B
WARNING:
Manufacturer
shall not be held liable for
damages that may arise from
procedures carried out by
unauthorized persons.
B
WARNING:
Product must
not be plugged in during
installation. Otherwise, there
is the risk of death or serious
injury!
B
WARNING:
If the door
clearance of the room where
the product shall be place is
so tight to prevent passing
of the product, remove the
door of the room and pass
the product through the door
by turning it to its side; if this
does not work, contact the
authorized service.
t 6+-/>2/:<9.?->98+8/@/80699<=?<0+-/
to prevent jolts.
t 8=>+66>2/:<9.?->+>6/+=>-7+A+C
from heat sources such as hobs, heater
cores and stoves and at least 5 cm away
from electrical ovens.
t <9.?->7?=>89>,/=?,4/->/.>9.3</->
sun light and kept in humid places.
t )9?<:<9.?-></;?3</=+./;?+>/+3<
circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls.
t0>2/:<9.?->A366,/:6+-/.38+8+6-9@/N
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls. Check if the rear
wall clearance protection component is
present at its location (if provided with the
product). If the component is not available,
or if it is lost or fallen, position the product
so that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance at
the rear is important for efficient operation
of the product.
t 989>38=>+66>2/:<9.?->38:6+-/=A2/</
the temperature falls below -5°C.
3.2 Installing the plastic wedges
Plastic wedges supplied with the product
are used to create the distance for the air
circulation between the product and the rear
wall.
1.
To install the wedges, remove the screws
on the product and use the screws supplied
together with the wedges.
2.
Insert the 2 plastic wedges onto the rear
ventilation cover as illustrated in the figure.