ARCAIR SLICE PACKAGE, Инструкция по безопасности и эксплуатации

Страница: 9 / 34

SLICE EXOTHERMIC CUTTING EQUIPMENT
2-1 89250848 INTRODUCTION
2.01 How To Use This Manual
This Service Manual applies to just specification or part numbers listed on page i.
To ensure safe operation, read the entire manual, including the chapter on safety instructions and warn-
ings.
Throughout this manual, the words WARNING, CAUTION, DANGER, and NOTE may appear. Pay particu-
lar attention to the information provided under these headings. These special annotations are easily
recognized as follows:
NOTE!
An operation, procedure, or background information which requires additional empha-
sis or is helpful in efficient operation of the system.
!
CAUTION
A procedure which, if not properly followed, may cause damage to the equipment.
!
WARNING
A procedure which, if not properly followed, may cause injury to the operator or others
in the operating area.
WARNING
Gives information regarding possible electrical shock injury. Warnings will be enclosed
in a box such as this.
!
DANGER
Means immediate hazards which, if not avoided, will result in immediate, serious
personal injury or loss of life.
Additional copies of this manual may be purchased by contacting Arcair at the address and phone
number in your area listed on back cover of this manual. Include the Owner’s Manual number and
equipment identification numbers.
Electronic copies of this manual can also be downloaded at no charge in Acrobat PDF format by going
to the ESAB web site listed below
http://www.esab.eu
2.02 Equipment Identification
The unit’s identification number (specification or part number), model, and serial number usually appear
on a data tag attached to the rear panel. Equipment which does not have a data tag such as torch and
cable assemblies are identified only by the specification or part number printed on loosely attached card
or the shipping container. Record these numbers on the bottom of page i for future reference.
SECTION 2:
INTRODUCTION