Operation instructions
10
To operate and to remove the shield
Pull outward on lower left side of the shield to
release the lock system, to raise the shield.
The shield can only be opened when the lock
system has been released. To close the
shield smoothly, push down on the middle of
the upper edge of the shield.
To remove the shield, remove screws, washers
and guides from the helmet. To replace, posi-
tion the shield in place and install guides,
washers and screws as illustrated.
Notes on shield with tear-off posts and instructions for
tear-off (optional)
Proper tear-off (optional) is for racing use only.
Never use for street riding.
Some tear-offs come with protective film on
one or both sides. Be sure to remove any films
that may be present (<A>.
To install tear-offs, slip the hole of the shorter
end over the right (throttle side as you sit on
the motorcycle) shield post. Lay the tear-off
across the shield and slip the other hole over
the left (clutch side) shield post <B>.
