ARAG Skipper 467031, Руководство по установке

Страница: 6 / 24

6
4.3 General precautions for locating the SKIPPER and cable runs
• Positioning the SKIPPER device in the cab:
- DO NOT place the navigator in areas subject to excessive vibrations and shocks or
close to moving parts which might cause damages;
- Mount the remote control unit in a visible position, without obstructing the opera-
tor’s view, and within easy reach by hand;
- Take care to position the device away from moving parts to avoid accidental opera-
tion of its keys.
• Inserting the connectors:
- Fit supplied O-rings into connectors and then connect paying special attention to
the notch. Press gently and then tighten the ring nut.
CAUTION: do not use tools to tighten down the connector locking collars.
- Do not force the connectors by pushing too hard or bending them: the contacts
can be damaged and monitor operation compromised.
• Securing the cables:
Note the various connections required for the SKIPPER system to operate, the ne-
cessary length of the cables, and ensure that there is sufficient space for the cable
runs and connectors:
- Route the cables in such a way that twisting and machine movements cannot da-
mage or break them.
- If, due to limited space, the cabling has to run around a corner, make sure that the
bend is not too sharp as this may cause the cable to break.
• Use ONLY the cables and accessories listed in the catalogue; these have the cor-
rect specifications for their intended application.