ARAG Skipper 467031, Руководство по установке

Страница: 11 / 24

11
4.9 Treatment status signal
• If the machine is equipped with a treatment control, such as a switch on the control valve, the
SKIPPER can be connected to a corresponding treatment status signal, so that it receives a
+12 Vdc signal directly from the control itself when treatment starts.
We recommend that the control be connected to the main control valve positive pole.
Since the current in question is very low, the cable connection to the control need not be of any
special cross-section.
CAUTION: the connection to the treatment control must be done by a qualified tech-
nician.
ARAG is not liable for damage to the system, persons, animals, property or crops
due to incorrect connection of the above control or modifications to the system,
cabling, connectors or any other components required to make the connection.
• If the treatment control connection is not made, the operational status of the equipment must be
entered into the SKIPPER manually with the key on the remote control unit.
• If SKIPPER is connected to BRAVO 300S, there is NO need to make any connections to enable
treatment start command.
4.10 Connections to BRAVO 300S
Before making the connection, carefully read par. 4.3 - General precautions for loca-
ting the SKIPPER and cable runs.
Connect devices to SKIPPER with cable 2 as shown in figure 1 (Section 3 - Items included in the
supply).
Connection points are specified at par. 4.7 - Electrical Connections - main diagram.