ARAG Skipper 467031, Руководство по установке

Страница: 12 / 24

12
4.11 Connection to the power source
CAUTION!
To avoid short circuits, do not connect the power cable connector before the installa-
tion is completed.
Before powering up the guidance monitor and remote control unit, make sure the
engine battery voltage rating is correct (12 Vdc).
SKIPPER is powered directly by the vehicle battery (12 Vdc): SKIPPER should ALWAYS be switched
on from the satellite navigator, whereas it should be switched off by means of the appropriate button
on the control panel.
The vehicle battery may go flat if SKIPPER stays on for a long time when the engine
is not running: in case of long stops - with engine OFF - disconnect SKIPPER from
the battery.
+ -
3 A
R
ed
Blac
k
CAUTION:
• The power circuit must ALWAYS be fitted with a 3 Amp automotive fuse.
• All battery connections must be made with cables with a minimum cross section
of 1 mm
2
.
• Use cables with suitable terminals to ensure correct connection of each individual
wire.
Fig. 13