Accessories
29 |
A R 5 I N S T R U C T I O N M A N UA L
If your housing is equipped with the optical flash option, you
will need to use a provided optical flash trigger.
STEP 1:
Remove the battery trays from the flash trigger
STEP 2:
Insert the provided CR 2045-coin cell batteries inside
the 2 battery trays (positive side up).
WARNING:
Only use 2 x CR 2450-coin cell batteries to power your flash trigger. Using other
types of batteries could cause damage to your flash trigger.
STEP 3:
Insert the battery trays inside the flash trigger. The front LEDs and the rear LED
will flash once.
STEP 4:
Insert your flash trigger in your camera hot shoe using the bottom mount. Make
sure it is pushed all the way in to align the LEDs with the bulkheads on the
housing.
STEP 5:
Upon the flash trigger being inserted into the hot
shoe, the rear LED will flash once. If it flashes red
the battery level is low, replace them with new
ones. If it flashes green, the battery levels are
good.
STEP 7:
Push the optical cable bushing in their sockets in
the optical bulkheads.
NOTE:
The slim flash trigger battery should be able to fire strobes at least 15,000+
times. However, some CR 2450 cells have a very limited shelf life, so make sure
to change your batteries if your flash trigger has not been used for a few
months.
