26 |
A R 5 I N S T R UC T I O N M A N UA L
Accessories
To use your vacuum monitoring system:
STEP 1:
Prior to closing your housing, put your Surveyor sensor in vacuum mode by
pressing the activation switch on the board (#3 on page 22). The Surveyor green
LED should be flashing rapidly upon activation.
STEP 2:
Close your housing using procedure outlined in the
section
Housing
Closing (page
STEP 3:
Remove the valve plug (#1) by sliding the quick-disconnect collar (#2).
STEP 4:
Insert the pump stem (#5) in the pressure valve and release the quick disconnect
collar (#2).
STEP 5:
Make sure the pressure release plug (#6) is screwed all the way in (clockwise).
STEP 6:
Grip the vacuum and the pump at the connection of both parts firmly. Keep the
pump aligned with the vacuum. DO NOT BEND OR APPLY FORCES ON THE PUMP
FROM DIFFERENT DIRECTIONS, THIS COULD LEAD THE STEM TO BREAK.
