21 |
Surveyor board and Vacuum pump
Once a battery is installed, the moisture detection circuit of the Surveyor alarm
will remain on standby and does not need to be activated.
If not being used for a prolonged period of time (months), it is recommended
to remove the battery from the sensor circuit to avoid unnecessary drain.
Moisture detection LED code:
Standby mode
LED is off
System is on standby
Water detected
Red LED flashing with audible alarm
Water is making contact with probe
Note:
If you are only using the moisture detection system without the
vacuum, it is recommended to perform a quick test of the circuit
before every dive. To do so, simply moisten the tip of your finger
and establish contact between the board
probes (#7). If it fails to
activate the alarm, check that the battery is correctly inserted and
replace it with a fresh one if required.
