15 |
Port mounting
Port mounting
The AZ6/7 housing is equipped with a bayonet locking system that firmly
attaches compatible ports and extension rings.
STEP 1:
Before mounting the port, remove the O-ring seal from its groove and
carefully verify that the O-ring and its groove are free from scratches
or foreign matter. Lubricate the O-ring with a light coat of silicone
grease. Also check that the O-ring mating surface on the housing is
clean and free of any physical damage.
WARNING:
For proper handling of O-rings, follow the detailed instructions
outlined in the Care and maintenance - O-rings section page 30.
STEP 2:
Place the housing on its back on a soft and steady surface.
STEP 3:
Place the port or extension ring inside the housing bayonet. Align the
bayonet using the four alignment notches in the housing.
