Aquatic SERENITY W6AIR6060, Руководство пользователя и инструкция по установке

Страница: 20 / 89

20 Aquatic
Serenity Owner's Manual & Installation Guide
INSTALLATION INSTRUCTIONS
FREESTANDING MODELS
Serenity 11 & 13 Installation
Before the floor installation is complete, make sure the floor is level. Once the floor installation
is complete, determine the exact location of the bath and trace the contour of the
bath with an erasable marker pen.
NOTE:
You will need to remove the
wooden base attached to the bottom of the unit for shipping.
For information on electrical installation, maintenance and care,
troubleshooting and warranty, please refer to the Table of Contents.
1. Determine the exact location of the drain, air passage and the
two anchoring points at each end of the bath (see Diagram 3A).
2. To prevent the bath from moving sideways, secure the two anchoring
pins (3/8” x 3” lag bolts, not supplied) to the floor. Leave the lag bolts
1 1/2” above floor. Wipe off the marker tracings (see Diagram 3B).
3. Install the overflow and drain on the bath. Cut pipes to desired length
prior to assembly. Glue the first pipe section (PVC 1 1/2”) of the air
passage to go under the floor and make sure pins are lined up with holes
in tub. Apply a silicone seal under the rim of the base and lay the bath
down putting the pipes through the floor (see Diagrams 3C and 3D).
Immediately remove any excess silicone. Also see Top Views
Diagram 3E.
3E
SERENITY 11 BOTTOM VIEW
SERENITY 13 BOTTOM VIEW
3A
14"
9"
TOP VIEW
6" x 6"
BOX OUT
DRAIN HOLE
SERENITY 11 TOP VIEW
13"
9"
TOP VIEW
6" x 6"
BOX OUT
DRAIN HOLE
SERENITY 13 TOP VIEW
Cut pipes to desired
length prior to assembly
3D
3C
100% Silicone
20”
Pipes go through
the floor
Anchor Pins
SERENITY 11 SIDE VIEW
3B
20”
20 1/2”
Anchor Pins
SERENITY 13 SIDE VIEW
20”
20”
17”