Aquatic AquaFit 16, Руководство пользователя

Страница: 27 / 30

Aquatic Fitness System - Owner’s Manual
24
Troubleshooting Guide
Heating System
Symptom Problem Corrective Action
1. Temperature setting is
too low 1. Turn up the “set temperature” on the control panel
2. Dirty filter 2. Clean filter
Does not heat
3. Flow switch malfunction 3. Call your dealer for service
1. Temperature setting
too high
1. Turn down the “set temperature” on the control panel Too hot
2. High limit tripped 2. Call your dealer for service
Flashing
temperature of
34
q F ( # 1 q C)or
134
q
F (
#
56
q
C)
appears on the
display
Possible temperature sensor
failure Call your dealer for service
Hot Tub
Temperature
erratic Water level Fill hot tub to about six inches below the top of the spa or 1” (2.54 cm) to 2”
(5.08 cm) above the bottom of the tile line if your spa has tile.
1. Too much filtration 1. Reduce the number of filter cycles and/or the filter cycle duration
2. Temperature setting
too high
2. Turn down the “set temperature” on the control panel
Display reads
OVERHEAT
3. High limit or sensor
problem 3. Call your dealer for service
Electrical System
Symptom Problem Corrective Action
Will not turn on –
in any mode No power Check circuit breaker and/or GFCI
Turns on by
itself Normal automatic daily
filtration, or anti-freeze
cycle No action required
Light is out
Burned out bulb Replace bulb
1. Automatic timer
has shut pump off
1. Push JETS Button again to start another cycle. If desired, reprogram
automatic pump timer for longer duration.
Pump shuts
down
unexpectedly
while in use
2. Motor over-heated
and automatic
protective device
has shut down
pump(s)
2. If pump(s) will not restart when JETS Button is pushed, call for service
Make sure that the equipment panel vent area is not blocked. Vent blockage
can cause serious damage to your equipment.
1. Check water level, adjust if needed
2. Clean filter
If problem persists:
1. Turn power off at GFCI breaker, then back on
3 flashing lights
on the Topside
Control Possible sensor errors
If problem still persists: Call your dealer for Service