Aquatic AquaFit 16, Руководство пользователя

Страница: 14 / 30

Aquatic Fitness System - Owner’s Manual
11
Jets Operation
Pressing the Jets 1 button once turns Pump 1
on low speed. A second press turns it to High
Speed. A third press turns the pump off,
unless the pump has been automatically
activated during a heating cycle – in which
case a third press returns the pump to Low
Speed for heating. A built-in timer
automatically shuts the pump off after 20
minutes of operation. The Jets 1 Indicator light
(beside the button) will glow while the pump is
running.
Pump 1 powers the Swim Jets and/or
HydroTherapy Jets
. The diverter valve (see
the left picture) controls which set of jets gets
the water, and how much flows to each set.
(Note: If you have the Dual Temp model with
built-in spa, the spa side has a diverter valve
but the swim side does not.)
Note: Pump 1 also runs on low speed during
all filtering and heating cycles. During the filter
cycle the indicator light for Jets 1 glows. If
you manually press JETS 1 during a filter
cycle, that particular filter cycle disables to
give you control of the jet pump.
Pumps 2 and 3 provide high-volume water
flow to the Swim Jets.
Press the appropriate button once to turn on
Pump 2 or 3. The pumps work independently,
giving you flexible control over the amount of
water flowing from the Swim Jets. Pressing
either button a second time turns that pump
off.
A built-in timer will shut the pump(s) off after
20 minutes of operation unless you manually
shut them off earlier. The Jets 1, Jets 2 or
Jets 3 Indicator light beside the button will
glow when that pump is running.
Note for North American Models: If your
system was installed with less than the
maximum recommended electrical service for
heat and pumps, the heater will turn off when
the pumps run at high speed. If you have the
maximum electrical service, then you can
continue to heat your water while running the
pumps at high speed. Ask your dealer if you
have questions about your electrical service.