26
Specification
Watermaker are designed for use in clear seawater only.
Specification – AQUATEC Watermaker
DD 500
Hose dimensions (inner diameter)
Diameter thru-hull fitting
3/4", 19 mm recommended
Thru-hull fitting up to high pressure pump
1/2“ / 13 mm
Outlet over board: concentrate (Brine)
1/2“ / 13 mm
Fresh water flush, inlet pressure should not exceed 2.5 bar.
1/2“ / 13 mm
conservation/ cleaning
1/2“ / 13 mm
Pipe product water up to control panel
3/8“ PE pipe
Hose product water to fresh water tank
1/2“ / 13 mm
High pressure hose
¼“
Technical datas
Pc. membrane typ seawater SW 2540
1
Typ membrane
Polyamide Thin-Film Composite
Working pressure 3-4% salinity
55 - 60 bar, maximum 60 bar
Salt reduction
min. 99,5%
PH range
2 – 11
Chlorine tolerance
Less than 0,1 ppm
Seawater temperature
+ 4° bis 38° Celsius
Water production, 3,5% salinity, 25°C und 60 bar pressure
60 l/h
Power consumption motor, amps 12 / 24 Volt
44 / 22
Power consumption feed pump, amps 12 / 24 Volt
2,2 / 1,3
Filter
Sediment filter 5 micron
Cartridge 9 7/8“ x 2,5“ (251 mm x 65 mm)
Charcoal filter for fresh water flush
Cartridge 9 7/8“ x 2,5“ (251 mm x 65 mm)
