AquaPRO WaterPro, Руководство по обслуживанию

Страница: 15 / 40

Master Programming Mode
11. Regeneration Cycle Step Programming
This program step programs the Regeneration Cycle step times 1 through 5. Please refer to the chart below
for regeneran
t flow default cycle steps and times.
Regenerant Flow Cycle 1 Time Cycle 2 Time Cycle 3 Time Cycle 4 Time Cycle 5 Time
Down Flow Back Wash
10
Minutes
Brine
& Slow
Rinse
1 Hour
Rapid
Rinse
10
Minutes
Brine Tank Fill 12 Minutes N/A N/A
Back Wash Filter Back Wash
15
Minutes
Draw 0
Settling
Rinse
10
Minutes
Re
fill
0 N/A N/A
UF Back Wash Backwash
10
Minutes
Brine
& Slow
Rinse
1 Hour
Rapid
Rinse
10
Minutes
Brine Tank Fill 12 Minutes N/A N/A
Down Flow Double
Backwash
Back Wash
10
Minutes
Brine
& Slow
Rinse
1 Hour
Back
Wash
10
Minutes
Rapid Rinse 10 Minutes Brine Tank Fill 12 Minutes
Up Flow Brine Rinse 60
Back
Wash
10
Rapid
Rinse
10
Minutes
Brine Tank Fill 12 Minutes N/A N/A
Up
flow Variable Fill
Brine Rinse Variable Pause
60
minutes
Brine
Rinse
60
Minutes
Back Wash 12 Minutes Rapid Rise 10 Minutes
12. Media Volume
This program step sets the volume of the media in the resin tank.
— Press the Shift button to select the digit you want to modify.
— Press the Up or Down buttons to adjust this value.
— Press the Extra Cycle button.
13. Salt Dosage
This program step sets the salt dosage in the unit.
— Press the Shift button to select the digit you want to modify.
— Press the Up or Down buttons to adjust this value.
— Press the Extra Cycle button.
14. Brine Line Flow Control Size
This program step allows the selection of the desired brine line
flow control size in the unit (must match
physical brine line
flow control).
— Press the Up or Down buttons to adjust this value.
— Press the Extra Cycle button.
15. Auxiliary Relay Output
The next two displays are part of a series of settings used to program the optional relay output. The
first
setting turns the output on/off during regeneration only. The second turns the output on during service only,
every time a set volume of water used has accumulated.
NOTE: When auxiliary outputs are in the OFF (default) setting, press the Up or Down buttons to set
the
first
setting. Then press the Extra Cycle button to advance to the second setting.
CAUTION: Before entering Master Programming, please contact your local professional water dealer.
Page 15