Rise Digital Bath
installation instuctions
page 8
Place the paper template on the wall
in the desired location for the bath
control and mark all fixing points and
the data cable entry point. Remove the
template and drill a Ø16mm hole
at the appropriate position for the data
cable.
8
The data cable should be run in conduit to allow for replacement if
required.
!
Drill and prepare the four wall fixings for the controller using the
fixings provided.
9
Feed the control connection end of the
data cable through the centre hole in
the mounting template. Run a bead of
silicone sealant in the mastic groove
on the back of the mounting plate and
press into position onto the finished
wall surface. Ensure the data cable is
held securely by the narrow middle slot
of the mounting plate and fix to the
wall using the screws provided.
10
Plug the data cable into the rear of the
controller and push fully home. Slide the
controller assembly onto the mounting
plate. Secure the controller to the back
plate with the fixing screw located at the
base of the controller using a small
Posidrive screw driver.
11
Connect the 15mm copper pipe to the mixed water outlet on the
Digital processor. Using pipe clips as appropriate, ensure that all pipe
work is perpendicular to the processor, i.e. not putting any strain on
the fittings.
12
TO ENSURE OPTIMUM PERFORMANCE USE THE MINIMUM
AMOUNT OF ELBOWS.
!
