Aqualisa MIDAS 110, Руководство по установке

Страница: 16 / 36

INSTALLATION INSTRUCTIONS
MIDAS
110/220 ADJUSTABLE HEIGHT HEAD
16
8
Ensuring the O-ring is in the correct position on the recess of the spigot section on the mounting plate, place
the wall outlet onto the mounting plate in the 5 o’clock position and rotate clockwise until a stop is
reached.
9
Refit the locking screw taking care not to over tighten
10
Drill and prepare two fixing points between 520mm (minimum) and 830mm
(maximum) apart using the fixings provided, if suitable.
11
Pass the rail through the handset holder while keeping the slider levers depressed.
!
The top rail end bracket can be adjusted to suit existing screw holes in the
finished wall by sliding the bracket up or down the rail to suit the required
position.
12
Carefully slide the gel hook onto the rail under the handset holder.
!
Current Water Supply regulations state that the handset should not be allowed to pass a point 25mm
above the spill over level of the bath or shower tray. If this cannot be achieved, the hose must be
passed through the gel hook which has been designed to be utilised as a hose restraint.
13
Secure the top rail bracket into position using the screws provided, if suitable.
14
Attach the bottom rail end body onto the rail.
1
Drill and prepare two fixing points between 520mm (minimum)
and 830mm (maximum) apart using the fixings provided, if
suitable.
•
i
The top rail end bracket can be adjusted to suit existing screw holes in the finished wall, by
sliding the bracket up or down the rail to suit the required position.
16
8
Ensuring the O-ring is in the correct position on the recess of the spigot section on the mounting plate, place
the wall outlet onto the mounting plate in the 5 o’clock position and rotate clockwise until a stop is
reached.
9
Refit the locking screw taking care not to over tighten
10
Drill and prepare two fixing points between 520mm (minimum) and 830mm
(maximum) apart using the fixings provided, if suitable.
11
Pass the rail through the handset holder while keeping the slider levers depressed.
!
The top rail end bracket can be adjusted to suit existing screw holes in the
finished wall by sliding the bracket up or down the rail to suit the required
position.
12
Carefully slide the gel hook onto the rail under the handset holder.
!
Current Water Supply regulations state that the handset should not be allowed to pass a point 25mm
above the spill over level of the bath or shower tray. If this cannot be achieved, the hose must be
passed through the gel hook which has been designed to be utilised as a hose restraint.
13
Secure the top rail bracket into position using the screws provided, if suitable.
14
Attach the bottom rail end body onto the rail.
2
Pass the rail through the handset holder while keeping the slider
levers depressed. Ensure the handset holder is in the correct
orientation.
16