Aqualisa MIDAS 110, Руководство по установке

Страница: 21 / 36

2
If required, apply jointing tape to the threads and fit the eccentric
elbow connectors sufficiently to achieve a water tight seal,
terminating at 150mm centres to suit the exposed valve inlets.
3
Ensuring adequate provision to allow the water to discharge safely to waste, turn on the supplies
to flush the system through. Attach pressure test equipment and pressure test the system in
accordance with Water Supply Regulations.
4
Ensure the ¾” supply connections are temporarily capped to prevent any dirt or dust ingress into
the pipe work during the making good process. Remove the caps prior to connecting the shower
valve.
5
Place the cover plates onto the exposed ¾” threads, flush with
the finished wall surface and apply a thin bead of mastic if
required.
The cover plates may vary from the image shown.
6
Ensuring the inlet washers are positioned within the valve inlets,
offer the valve into position. Tighten the fixing nuts using a suitable
tool taking care not to overtighten. Unless in line filters are fitted
to the supply pipe work we recommend the rubber filter washers
should be used.
21
Image shows 220 cover plates
Image shows 220 shower column valve
A MINIMUM CLEARANCE OF 1.2M FROM THE TOP OF THE SHOWER
VALVE IS REQUIRED TO INSTALL THE SHOWER COLUMN
.