Aquagarden 2250-4500, Руководство пользователя

Страница: 7 / 44

For permanent installations to the mains supply, it is necessary to conform to the regulations of the
local electricity authority and this would include the use of a metal or plastic conduit to protect
the cable.
Attention has been drawn to the fact that the special rules may exist concerning the installation of
your pond pump (i.e. local building regulations). These pumps must not be used in swimming pools,
or areas where people are in contact with the water.
Always disconnect and isolate the product from the mains electricity supply whilst the equipment is
being installed, repaired, maintained or handled. Consult a qualified electrician if you are in any
doubt about wiring this product to the mains supply.
Important: This appliance can be used by children aged 8
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
the use of the appliance in a safe way and understand
the hazards involved. Children shall not play
with the appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
INSTALLATION
5
Warning
A Residual Current Device (RCD), also known as the Residual Current Circuit
Breaker (RCCB), with a tripping current not exceeding 30mA must be installed
in the supply circuit. A means of disconnection from the supply having a contact
separation of at least 3mm in all poles must be incorporated in the fixed wiring.
Warning -
The controller must be affixed vertically to a secure surface, 30cm
minimum above the ground. Install in a well ventilated area. Do not restrict
ventilation to the heat sink. IP56 weatherproof enclosure, do not submerge.
Caution hot surface, turn off power and allow to cool before removal.
EN
WARNING: Pump controller must be affixed
vertically to a secure surface, 30cm minimum
above the ground. Install in a well ventilated
area. Affix with the two screws and wall plugs
provided. DO not restrict ventilation to the heat
sink. IP56 weatherproof enclosure, do not
submerge. Caution hot surface, turn off power
and allow to cool before removal.
30cm (min)
Secure
surface