10
1/2 HP
TUR
BO
Locate the six cap screws set aside during preparation. (Refer to
Fig. 1
) Reposition the housing over the
venturi starting with the lower half of the housing.
Tilt housing downward to clear the lower lip of the
venturi. Raise the rear edge of the housing between the venturi and rear guard.
(See
Fig. 8
) Re-insert
the six cap screws through the rear guard eyelets and thread
loosely
to housing.
As you straighten the housing, it is important that the attached
liquid feed tube (Part #6) is inserted properly into the reservoir.
Adjust the feed tube (if necessary) so that it ends up centered and
inserted approximately 1/4" into the reservoir's center bearing.
(See
Fig. 9
)
Once the liquid feed tube is properly inserted, tighten the six cap
screws until snug.
Do not over tighten.
Ideally the liquid feed tube should not touch the inner wall of
the bearing. However, it will not cause undue wear if the tube
lightly touches
the bearing.
Note:
If shifting the housing does not center the tube, it may be
necessary to slightly re-form the tube. Remove the housing and
loosen the brass cap at the base of the tube to detach the tube
and cap. Slightly re-angle tube at the bend. Re-attach the tube and
housing. Check feed tube position.
Make sure liquid feed tube enters
about 1/4" into reservoir's bronze
bushing with minimal stress.
Fig. 9
H
OUSING
R
E
-A
TTACHMENT
Fig. 8
SST liquid
feed tube
(#6)
WARNING
1/4-20 x 3/8" button
head cap screw SST
(#54)
SST liquid
feed tube
(#6)
Housing
Assembly
Venturi
ATTACHING
Housing Assembly
◄
