4
FINAL ASSEMBLY
Carefully remove your Miss Vegas Deuce from the box and
place it atop the pre-built boat stand. Remove all remaining
components from the box.
You may wish to keep the
box in order to more easily transport and store your
Miss Vegas Deuce.
Decals have been provided for your Miss Vegas Deuce.
Simply cut them out, peel, and stick! See the photos on
the box for recommended decal placement.
TRANSMITTER ASSEMBLY
1. Slide off the battery door on the bottom of the transmitter.
Install four fresh “AA” batteries into the bottom of the transmitter
in the confi guration molded into the battery holder. Re-install
the battery door onto the bottom of the transmitter.
1. Power Light
2. On/Off Switch
3. Steering Trim
4. Throttle Trim
5. Throttle Reverse
6. Steering Rate
7. Steering Reverse
2. Turn the transmitter on using the switch on the front. The
red LED should light up. If the LED does not light up, turn the
transmitter off and check to make sure that the batteries are
installed properly. If you see a fl ashing LED, the batteries are
low and need to be replaced.
INSTALLATION OF RECEIVER BATTERIES
1. Locate the cowl locks on the rear hatch cover and slide
them forward.
2. Lift the rear of the canopy and slide it forward to access
the interior of the hull.
