Safety Instructions
Your pool contains a large quantity of water and is deep enough to potentially endanger life and health
unless the following rules are strictly observed. First-time users are the most at risk of injury. Make sure
everyone understands all the safety rules before entering the pool.
No Jumping or Diving
The top rail of your pool is not a walkway and must not be used for jumping or
diving. DO NOT PERMIT jumping or diving into the pool from a deck or the top
rail of the pool. Diving or jumping into the pool can result in serious injury or
even death by drowning.
Never use the pool alone or leave children unattended
NEVER permit the pool to be used unless it is attended by at least one adult other
than the bather. NEVER leave a child unsupervised in or near the pool. Someone
should always be available in case of an emergency.
Restrict access to the pool
DO NOT LEAVE chairs or other furniture beside the pool that could be used by a
child to climb into the pool. Ladders must be removed when the pool is not in use or
unattended. A fence or gate around the pool is strongly recommended and may be
required by law in some countries.
No Horseplay, No Alcohol or drugs
DO NOT PERMIT “Horseplay’ in and around your pool. Surfaces can be slippery and
hazardous when wet. The use of alcohol or drugs with pool activities is extremely
dangerous. Persons who have been drinking alcohol or taking drugs should not be
allowed in the pool and should be carefully supervised in the surrounding area,
Keep away from ladders while swimming
DO NOT swim under or behind the ladders as this can result in entrapment or
drowning. Remove ladders when not in use.
Warning:
Do not modify the pool and do not interfere with the structure of
the pool once it is assembled and filled with water. It could result in the pool
collapsing or in serious injury.
!
PART 5
INSTALLING THE TOP RAILS AND VERTICAL
SUPPORTS
This section n/a for Satinwood 3.6m (12ft) or 4.6m (15ft) Pools
a. Place the upper coupling [4] onto the upper edge of the pool wall, so that the flap
of the slip of the upper coupling is situated outside the pool.
b. ONLY ON 5.5m and 6.4m size pools there are vertical supports - Slide one end of
the upper rail [6] into the upper coupling [4]. Align the hole for the screw in the
flap with the hole for the screw in the top part of the vertical support [1]. The flap
of the clip of the upper coupling must be outside the vertical support. The vertical
support must be in a vertical position.
Attach the upper coupling to the vertical support with one self-tapping screw [3].
It is necessary to put heavy pressure on the vertical support Image 5-6).
c. Repeat the steps for each vertical support along the circumference of the
pool wall.
Hint:
Use the grooving on the pool wall to check the columns are vertical.
4. APPLY THE WARNING LABEL
a. Apply the warning label near to the point used for entering or leaving the pool.
NB:
The pool is not deep enough to jump into safely; any attempt to do so could
result in injury.
5. FINISH FILLING OF THE POOL
a. Fill the pool with water to 5 cm below the lowest hole in the pool wall.
Then proceed according to the Assembly Instructions for your skimmer.
Important:
The pool might buckle or shift while being filled with water. This is normal.
b. Attach the filter equipment to the skimmer installed, as per the appropriate
Instructions.
c. Fill water up to the level of the centre of the inflow front plate of the skimmer
and carry out primary disinfection of water (see Annex C). Your pool is now ready
for use.
d. When full we would recommend you leave your pool 2-3 days before trimming
any excess liner
Warning:
Anyone using the pool should read the Safety Instructions beforehand
and observe them. The Safety Instructions are included in Part 6.
5-6
Round Satinwood Pool
12
