PART 4
ASSEMBLING THE POOL WALL AND LINER
1. MARK OUT THE AREA
a. Ideally, choose a sunny day for assembly.
Do not attempt to assemble the
pool when it is windy.
You will require the assistance of at least one adult for
smaller pools and several adults for larger pools.
b. Unwind the pool wall and place it in the middle of the pool base on a piece of
plywood (Image 4-1). Make sure that the pre-punched holes for the skimmer are
situated at the top part of the wall.
Important:
Before unwinding the wall, make sure you locate the holes for the
skimmer. They should be at the beginning of the wall, as illustrated in Image 4-2. If
this is not the case, the wall has been wound in the opposite way during production.
If so, unwind the wall in the opposite direction to the one shown in Image 4-2, i.e. in a
clockwise direction.
c. Start to unwind the wall and at the same time insert its lower edge into
the curved lower rail. The beginning of the wall must be situated above one
connecting piece [2] (Image 4-2 and Fig. 4-3) and the holes for the skimmer
and return fitting must be situated at the place where the filter equipment is
to be situated.
d. Unwind the wall and install the rails from the upper part [14] (Fig. 4-4).
Leave a clearance of approximately 1 cm between individual rails
e. Continue around the entire base until the entire wall is constructed, inserted into
the lower rails and fitted with the upper rails.
Hint:
Please note that the 3.6m (12ft) & 4.6m (15ft) Satinwood Pools have plastic
rails so images on this page may differ
Hint:
You may need to trim the plastic rails (bottom & top) to suit the length of the
steel outer to complete the circle.
Note:
Dia 4-3 & 4-4 are not applicable to the 3.6m or 4.6m Satinwood Pools.
4-1
4-2
4-4
4-3
Round Satinwood Pool
7
