d. Gradually remove the plastic clips on the upper edge of the wall, always one at
a time and smooth any wrinkles on the liner. Install the plastic top rail on the
smoothed part immediately one after another (Fig. 4-18).
e. After having smoothed all wrinkles on the liner, cut away the protruding part of
the last plastic bar so that its end sits close to the adjacent bar (Image 4-19).
Note:
It is normal for there to be slight waves on the liner during installation. This is
caused by movement of the vinyl material used to protect the liner during packing.
Note:
The liner is not a structural part of the pool. Its main function is to prevent
water from flowing out of the pool. Water pressure is maintained by the walls and
structural elements of the pool. The liner must fit properly to the ground, corner filling
and pool wall; it must never bear the weight of the water, as this could damage it.
Note:
Depending upon your size of pool the top rails may differ from the picture
shown. The Satinwood 3.6m & 4.6m pool have plastic top rails.
9. PROCEED WITH PART 5 OF THE INSTRUCTIONS
4-18
4-19
Round Satinwood Pool
11
