© 2002 New Aqua LLC dba Aqua Systems • 7785 East US Hwy 36 • Avon, IN 46123
18
Series SC
Installation, Operation,and
Maintenance Manual
Service
Cleaning the Brine Tank:
1. Remove the brine tank cover.
2. Scoop out as much old salt as possible.
3. Disconnect brine tubing from safety brine valve at brine
well.
4. Remove safety brine valve from brine well.
5. Place a hand in brine well to hold overflow nut and remove
two piece overflow.
6. Remove brine well and grid plate (salt shelf) from the brine
tank.
7. Remove any remaining salt and impurities from brine tank.
8. Using clean water and a brush or rag, wipe and rinse inside
of brine tank. Also wipe and rinse the grid plate and brine
well.
9. Reassemble brine tank reversing steps 3 - 6. see note at
right
10. Put brine tank in place making sure there is no debris or
foreign material beneath it.
11. Reconnect brine tubing to safety brine valve.
12. Add water to the brine tank to a level of 4” above grid plate
on a round brine tank or 6” above the grid plate on a square
or a rectangle brine tank.
13. Add new salt. Do not use any of the old salt that came out
of the brine tank.
14. Follow the disinfection instructions listed on page 12.
15. Put on brine tank cover.
If grid plate is used and it is damaged or
cracked, replace with new one.
Note:
Brine Well
Safety Shut Off
Grid Plate
