Aqua Systems AQPC-35, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 20

9
4. Place the Base Assembly through the mounting
hole on the sink or counter top.
Drop the handle of the Wrench through the
Faucet Base opening. This will separate and
orient the Toggle Wings. Position the Faucet
Base so that the arrows are pointing in the
direction that the faucet handle will face.
Tighten the
1
⁄
8
” Screws with a Phillips
screwdriver. When the Toggle Wings make
contact with the mounting surface, adjust the
Faucet Base to the exact desired position.
Tighten the
1
⁄
8
” Screws an additional 2-3 turns
while holding the Faucet Base in place.
TAB
HOSE BARBS
3/8” QUICK
CONNECT FITTING
BLACK 3/8” POLYTUBE
(TO DRAIN CLAMP)
BLACK 1/4” POLYTUBE
(TO DRAIN PORT
ON RO SYSTEM)
BLUE 3/8” POLYTUBE
(PRODUCT OUTLET)
5. Connect the tubing to the Faucet. Push the
Blue
3
⁄
8
” Polytube into the
3
⁄
8
” Quick Connect
Fitting. Push the Black
3
⁄
8
” Polytube onto the
large Hose Barb. Push the Black ¼” Polytube
onto the small Hose Barb.
6. Determine which direction the handle should
face (right or left). As shown, it can be mounted
in two directions. With the handle facing the
chosen direction, slide the fastened Polytubes
through the Faucet Base and slide the Faucet
Assembly into the Faucet Base, lining up the
tabs on the Faucet with the slots on the Base.
The Faucet Assembly may have to rotate
slightly to get the tabs into the slots. When
aligned, apply firm downward pressure to
get the Faucet to fully seat. After the Faucet
Assembly is seated, lock it into place by
rotating it clockwise about 30 degrees.