background image

12

E.  Position the Drinking Water Holding Tank and 

Make the Final Hose Connections. 

1.  Check the tank precharge pressure. Make sure 

it is between 5 to 7 psig. If not, use a bicycle 

hand pump or other pump to bring the pressure 

up to the 5 to 7 psig range.

2.  Pull the cap/plug off the top of the tank where 

the Tank Shut–Off should go. (Refer to Fig. 1, 

page 5.)

3.  Wrap Teflon tape three times around the ¼" 

male outlet thread. Wrap in the direction of the 

threads (clockwise when looking down on the 

Holding Tank). The tape will act as a thread 

sealant. Screw on the Holding Tank Shut–Off 

Valve.

4.  Locate the 3/8" Yellow Tubing connected to the 

elbow on top of the manifold and run the tubing 

along its course to the tank and trim to length. 

Insert tubing into the Holding Tank Shut–Off 

Valve. Make sure the tubing is pressed all the 

way in to create a pressure tight connection. 

F.  Start Up

  At time of start up and each time the filters are 

changed the system should be sanitized (also 

 

see Operation and Maintenance  Sec. V, B.1–4).
1.  Sanitizing the system. Use a drip pan to aid 

clean–up. 

 

NOTE:

 The system should be sanitized 

BEFORE installing the Sediment/Carbon 

Prefilter, the Activated Carbon Post Filter or the 

R.O. Membrane.
•Use a good quality unscented 5¼% liquid 

chlorine household bleach. 

•Open the Dispensing Faucet and open the 

Holding Tank Shut–Off Valve (the handle 

should be parallel with the valve body). 

•Remove the plug on the underside of the 

manifold labeled “SEDIMENT/CARBON”. 

Pour one capful of bleach (this is 

approximately 2 tsp. or 10 ml) into one of the 

white Housings. Insert Housing O–ring into 

the Housing groove, (press firmly in place). 

Engage and firmly tighten the Housing hand 

tight only.

•Remove the plugs labeled “MEMBRANE” and 

“ACTIVATED CARBON” from the underside of 

the manifold. To each of the remaining white 

Housings, add one capful of bleach. Insert a 

Housing O–ring, engage and firmly tighten the 

Housings hand tight only.

•Slowly open the Feed Water Saddle Valve 

(turning counter clockwise). 

•As soon as the water begins to come out of 

the Dispensing Faucet, close the Faucet.

•Let stand for 15 minutes. 

 

NOTE:

 During this time, check the system 

carefully for leaks. 

•At the end of 15 minutes, CLOSE the Feed 

Water Saddle Valve and open the Dispensing 

Faucet. 

•Allow the Holding Tank to completely drain, 

then remove the Sediment/Carbon Prefilter 

Housing (the farthest of the three from the 

 

In–Out ports), empty, and install the 

Sediment/Carbon Prefilter. Firmly tighten the 

Housing hand tight only. 

•Remove the Activated Carbon Post Filter 

Housing (the closest of the three to the 

 

In–Out Ports), empty, and install the Activated 

Carbon Post Filter. Firmly tighten the Housing 

hand tight only. 

2.  Installing the R.O. Membrane:

•Remove the R.O. Membrane Housing, (the 

middle one), and empty. 

•Insert the Membrane up into the manifold. (The 

O–rings should be up toward the manifold.) 

Check the Housing O–ring for proper position 

in its groove, engage and firmly tighten the 

Housing hand tight only.

3.  Rinsing the system: 

•Slowly open the Feed Water Saddle Valve fully 

counter clockwise. 

•The Holding Tank Valve should be open.
•Check the Air Gap Window on the Dispensing 

Faucet to be sure that the drain water is 

flowing. The RO System is now making water.

•Do not open the Faucet for at least 8 hours.
•Do not use the first three full tanks of water.

 

CAUTION:

 The RO Membrane is shipped 

with a preservative in it. To ensure proper 

rinsing of the R.O. Membrane it is important 

to wait at least 8 hours before emptying each 

tank.

  When the Faucet is first opened, expect air 

and carbon fines (very fine black powder) 

from the Activated Carbon Post Filter to be 

rinsed out. This is normal for the first tank of 

water or after the Activated Carbon Post Filter 

is changed.

SECTION V.  OPERATION & MAINTENANCE

A.  Normal Operation 

1.  It is normal for the Total Dissolved Solids (TDS) 

of the water to be higher than normal during 

the first 5 gallons of operation; this is due to the 

sanitizing solution and the new Post Filter. 

Содержание AQPC-35





















Отзывы: